• Aqua-Flex
• Solar-Flex
• Speed-Flex
• Flex 310 M
• Flex 310 Polyurethane
• Flex and Bond
• Fast-Bond
• Silicone
• Black Seal
• Plastoseal

WEICON Speed-Flex

The new Power-Adhesive

• fast
• strong
• universal
• immediate adherence even on vertical surfaces

Speed-Flex - the fast, strong and universally usable power adhesive. Replaces traditional fixings like screws, pegs, rivets, etc. Speed-Flex is pasty and stable and, thus, suitable for problem-free bonding even on vertical surfaces both in-house and outside.

Many materials, like metals, plastics (except PE, PP, PTFE), concrete, marble, natural and artificial stone, ceramic, enamel, gypsum, plates of MDF, wood, flake or gypsum plaster boards can be bonded permanently to themselves and among each other.

SEspecially on vertical surfaces where additional fixing is not possible or desired, Speed-Flex offers numerous application possibilities, e. g.:

• fastening of cable conduits to walls, ceilings and floors
• bonding of mopboards and corner clips
• bonding of stairs
• fixing of insulating material, e.g. insulating boards

Speed-Flex is a stable paste and levels out unevennesses (gap-filling). It is free of silicone and solvents, overpaintable (“wet-in-wet”), nonshrinking and neutral in odour when curing.

Instructions for use:

Best bonding results are only achieved on clean, oil-, grease- and dust-free surfaces.

Technical data:

• Processing temperature: +5°C to +35°C
• Skin-over time*: approx. 10 minutes
• Cure speed*: approx. 3 mm/24h
• Temperature resistance: -40°C to +80°C (shortly up to +120°C)
• Tensile strength (DIN 53504): 2,2 N/mm²
• Shore-A-hardness: 58
• Colour: as printed onto the cartridge
• Shelf life*: 12 months in unopened cartridge

* Standard climate: +23°C and 50% relative humidity of air (DIN 50014-23/50-2)

Lieferformen:

• 310 ml cartridge, white, Art.-No.: 13600310
• 310 ml cartridge, black, Art.-No.: 13601310
• 310 ml cartridge, grey, Art.-No.: 13602310

>> Brochure/ Technical data
>> EC Safety data sheet (Overview)

Important Note:
All specifications, recommendations and techncial data are based on laboratory tests under optimum conditions resp. on practical experience. They have been compiled most carefully. Nevertheless, a claim cannot be derived from them. We therefore recommend to carry out own tests before application. The user bears the only responsibility for non-appropriate or other than specified applications.